<div dir="ltr">For the "Cases" presentation, here is my "Toblerone for Christmas".  The tube contains a li-ion 18650 battery.  On the outside is a <a href="https://www.aliexpress.com/item/2030115519.html?spm=a2g0o.cart.0.0.4a563c00Yoz8Pz&mp=1" target="_blank">battery charge controller</a>, a <a href="https://www.aliexpress.com/item/1059369726.html?spm=2114.12010615.8148356.1.16405813tWKCKy">DHT22 temperature and humidity sensor</a>, and an ESP32 Dev Kit in the dead bug position.<div>Start with a piece of coroplast 3.75 inches by 4.5 inches, with the tubes running along the long length.  Score across the tubes one inch in from each end, then along the tubes 1.25 inches in from the edges.  Fold, duct-tape to close the tube, and trim.  The red elastic keeps the wire contacts pressed against the battery ends. Hot glue the charger and dht sensor to the case.  If I hot glue the ESP32 to the case, I can get rid of the green elastics but I'm nervous about heat dissipation.  I had to use a low current (0.7 amp) power block into the charge controller to avoid overheating it.</div><div><br></div><div><img src="cid:ii_kihrnx2h0" alt="20201209_091637.jpg" width="471" height="339"><img src="cid:ii_kihrnx2r1" alt="20201209_092625.jpg" width="353" height="471"><br></div><div><br clear="all"><div><br></div>-- <br><div dir="ltr" data-smartmail="gmail_signature"><div dir="ltr"><div>George Bowden, vice president, Victoria Computer Club<br><a href="mailto:gtbowdeng@gmail.com" target="_blank">gtbowdeng@gmail.com</a></div></div></div></div></div>