<div dir="ltr"><div dir="ltr"><div class="gmail_default" style="font-size:small">George,</div><div class="gmail_default" style="font-size:small">Re: grounding 2- twisted pair. The only communication that works on two physical wires that I'm aware of is the Dallas 1-wire  and the CAN bus used in cars and industrial applications. In both cases there is nothing to ground. The CAN bus is available in PSoc 5 microcontroller from Cypress Semiconductors. Like all networks it requires additional hardware and a lot of spare time! Good luck on your project.</div><div class="gmail_default" style="font-size:small"><br></div><div class="gmail_default" style="font-size:small">Below is a link on a network using 1-wire for home automation.</div><div class="gmail_default" style="font-size:small"><br></div><div class="gmail_default"><a href="https://www.instructables.com/Home-automation-project-based-on-1-wire-devices/">https://www.instructables.com/Home-automation-project-based-on-1-wire-devices/</a><br></div></div></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Sun, Oct 25, 2020 at 11:13 AM George Bowden <<a href="mailto:gtbowdeng@gmail.com">gtbowdeng@gmail.com</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><div dir="ltr">Hi all<div>How to ground devices on a DIY low speed fault tolerant Can Bus??</div><div><br></div><div>

 I'm planning about a dozen sensors

in several rooms in my apartment

, a couple actuators, a few micro controllers and a Raspberry PI communications hub that connected to the internet for sending SMS messages to my phone .  

STM32 microcontrollers don't normally come with wifi so a wired network of these cheap devices in an apartment is reasonable. </div><div><br></div><div>I've chosen a single unshielded twisted pair Can Bus, tacked in the ceiling corners where it is almost invisible.  Yes, I thought about doing it other ways and chose this.  The antenna aspects might be challenging..  </div><div><br></div><div>I'm using the <a href="https://en.wikipedia.org/wiki/CAN_bus#/media/File:ISO11898-3_Waveform.svg" target="_blank">fault tolerant low speed can bus standard.</a> The bus will be optically isolated from the balcony.   Can I use ground  from AC power as a common ground between devices?  I think ground loops in this environment will be negligible. </div><div> </div><div><div><img src="cid:ii_kgpe96b70" alt="image.png" width="471" height="425"><br></div></div><div><br clear="all"><div><br></div>-- <br><div dir="ltr"><div dir="ltr"><div>George Bowden, vice president, Victoria Computer Club<br><a href="mailto:gtbowdeng@gmail.com" target="_blank">gtbowdeng@gmail.com</a></div></div></div></div></div>
-- <br>
Projects mailing list<br>
<a href="mailto:Projects@vicpimakers.ca" target="_blank">Projects@vicpimakers.ca</a><br>
<a href="http://vicpimakers.ca/mailman/listinfo/projects_vicpimakers.ca" rel="noreferrer" target="_blank">http://vicpimakers.ca/mailman/listinfo/projects_vicpimakers.ca</a><br>
</blockquote></div>